Returns a feature's orientation. This will have different possible return value, based on the input geometry type. Note that the orientation will always be no_orientation for any geometries not listed below.
Area
If the input is an area geometry which fits the right-hand or left-hand rule, the attribute will be set to the value right_hand_rule or left_hand_rule, respectively. The attribute will not have a meaningful value for degenerate areas, such as areas with a figure-8 boundary, or areas that are actually a line or point.
The right-hand rule requires that, on a walk of the area's coordinates, the area is on the right-hand side. Thus, outer boundaries must be clockwise and inner boundaries must be counterclockwise. The opposite is true for the left-hand rule.
Surface
If the input is a surface geometry, where all parts of the surface are consistently oriented, the attribute will be set to the value valid_surface_orientation. If the parts are unoriented or inconsistent, the attribute will be set to the value no_orientation.
Solid
If the input is a solid geometry, where all of the normals point away from the interior of the solid, the attribute will be set to the value valid_solid_orientation. If all of the normals point towards the interior of the solid, the attribute will be set to the value reversed_solid_orientation. In all other cases, the attribute will be set to the value no_orientation.
Parameters
Orientation Attribute
Name of the attribute that holds the orientation returned.
Editing Transformer Parameters
Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace. More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers. To access a menu of these options, click 
beside the applicable parameter. For more information, see Transformer Parameter Menu Options.
Transformer Categories
Search FME Knowledge Center
Search for samples and information about this transformer on the FME Knowledge Center.