Ensures that features with polygon geometry have an area that is equal to, or in excess of, the specified minimum area.
Features that were scaled will be output via the Enlarged output port.
Features that were not scaled will be output via the Untouched port.
Features with 0 area, or have non-area geometry, will be output via the <Rejected> port.
This is the area, expressed in ground units, that all output features will exceed. You can also choose to use the area of a selected attribute.
Any feature with polygon geometry that is smaller than the specified area will be scaled such that the geometry's area meets the required minimum value. The center of gravity of the feature will remain unchanged.
Editing Transformer Parameters
Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace. More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers. To access a menu of these options, click beside the applicable parameter. For more information, see Transformer Parameter Menu Options.
Search FME Knowledge Center
Search for samples and information about this transformer on the FME Knowledge Center.