List of Transformers

You are here: Point CloudPointCloudCreator

PointCloudCreator

Creates a new point cloud feature with the specified size and components and sends it into the workspace for processing.

Output Ports

ClosedCreated

Point cloud feature

Parameters

Point Cloud Properties

ClosedX Component Type and Y Component Type

Specifies the type of the x and y components. When an integer type is specified, the component values will be ascending integers (e.g. 0, 1, 2, ...), and the component will have a scale and offset value specified by other parameters (e.g. Average Spacing Along X and X Lower Left Coordinate). When a floating point type is specified, the component values will be multiplied out (e.g. min, min + 1*spacing, min + 2*spacing, etc.).

ClosedSize Specification

This parameter specifies how to create the points in the point cloud: either by using origin and size parameters, or extents parameters.

ClosedX Lower Left Coordinate and Y Lower Left Coordinate

The parameters specify the origin for the lower-left corner of the feature as a whole.

ClosedWidth and Height

These parameters define the width and height of the point cloud, in ground units.

ClosedAverage Spacing Along X and Average Spacing Along Y

These parameters specify how many points per ground unit should be in the output point cloud.

ClosedX Upper Right Coordinate and Y Upper Right Coordinate

These parameters specify the origin for the upper-right corner of the feature as a whole.

ClosedRotation

The rotation angle is measured in degrees counterclockwise from horizontal, and measures the rotation of the primary axis from horizontal.

Z Values

ClosedZ Pattern

This parameter specifies how the points in the cloud are given Z values. The Z values will be assigned as follows:

  • Flat: Every point in the cloud will have a z value specified by the minimum z.
  • Sloped: The points will have z values between minimum and maximum arranged in a gradient throughout the point cloud.
  • Trigonometric: The points will have z values between minimum and maximum arranged in a trigonometric pattern through the point cloud. Note that this pattern requires that z be a floating point type.
  • None: The point cloud will not have a z component.
ClosedZ Component Type

Specifies the type of the z component.

ClosedZ Minimum and Maximum

These parameters specify the minimum and maximum z value in the cloud.

Component Values

ClosedValue Pattern

If the Value Pattern is:

  • Single Value: the component will have a value specified by its minimum
  • Checkered Pattern: the component will have values arranged in a gradient throughout the point cloud
  • Checkerboard: the component will have values alternating between its min/max

Note: The point cloud must contain at least 8 rows and 8 columns in order for Checkered Pattern or Checkerboard to be used. Smaller point clouds will always be filled with a single value.

ClosedValues

Specifies each component to generate, the type of that component, and the minimum and maximum values for the component.

Example Output

Editing Transformer Parameters

Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace. More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers. To access a menu of these options, click beside the applicable parameter. For more information, see Transformer Parameter Menu Options.

Transformer Categories

Point Cloud

Search FME Knowledge Center

Search for samples and information about this transformer on the FME Knowledge Center.

Tags Keywords: point "point cloud" cloud PointCloud coerce LiDAR split creator create sonar