MRF2DDangleRemover

Each feature that is output through the Cleaned port will have a new attribute "mrf_clean_status" added to specify whether the feature was modified, created, or unchanged in the cleaning process. The possible values of this attribute are "Modified", "Created" and "Original".

If Dangle Action is set to Remove Short and Flag Long, for each feature that is a dangle but is longer than this tolerance, a point, label, or circle (depending on the value of Flag Type) will be output through the Flagged port.

If selected, each group of features with the same values in the Group By attributes will be processed separately from other groups.

Note: How parallel processing works with FME: see About Parallel Processing for detailed information.

This parameter determines whether or not the transformer should perform the work across parallel processes. If it is enabled, a process will be launched for each group specified by the Group By parameter.

Parallel Processing Levels

For example, on a quad-core machine, minimal parallelism will result in two simultaneous FME processes. Extreme parallelism on an 8-core machine would result in 16 simultaneous processes.

You can experiment with this feature and view the information in the Windows Task Manager and the Workbench Log window.

No: This is the default behavior. Processing will only occur in this transformer once all input is present.

By Group: This transformer will process input groups in order. Changes on the value of the Group By parameter on the input stream will trigger batch processing on the currently accumulating group. This will improve overall speed if groups are large/complex, but could cause undesired behavior if input groups are not truly ordered.

Cleaning tolerance is used as the default tolerance unless the Feature Tolerance Attribute is specified and valid. The minimum tolerance allowed is 0.0.

The number of layers used in cleaning the data is determined by the number of different tolerance values of input features. Features that have the same tolerances are processed as being on the same layer.

The default value is 1.0 and the minimum value is 0.0.

If Dangle Action is set to Remove Short and Flag Long, for each feature that is a dangle but is longer than this tolerance, a point, label, or circle (depending on the value of Flag Type) will be output through the Flagged port.

For each feature that is a dangle but is longer than the flag size tolerance, this parameter sets the flag type as a point, label or circle, if Dangle Action is set to Remove Short and Flag Long.