Input Ports
Input
- If the geometry of the input feature was a face or an area, then the geometry is replaced with a solid.
- If the geometry of the input feature was linear, then the result is a composite surface geometry.
Output Ports
Output
The features with the extruded geometries are output through this port. Extrusions created from surfaces may have surface normals pointing out or in, depending on the direction of the extrusion vector. All other extrusions will have surface normals out.
Parameters
Direction
The direction the extrusion vector should follow. To extrude along the z axis, select Vertical. To extrude along a specific vector, select Specified. To extrude along a surface normal in the case of faces, and vertically in the case of polygons, select Auto.
Distance
The desired length of the extrusion. You can enter the extrusion distance, the value can be taken from an existing feature attribute (select the attribute name from the pull-down list), or this value can be left blank. If it is blank, the distance will be taken as the length of the Specified vector, or else defaulted to a value of 1.
Extrusion Vector X
You can enter the x component of the extrusion vector, or the value can be taken from an existing feature attribute (select the attribute name from the pull-down list).
Extrusion Vector Y
You can enter the y component of the extrusion vector, or the value can be taken from an existing feature attribute (select the attribute name from the pull-down list).
Extrusion Vector Z
You can enter the z component of the extrusion vector, or the value can be taken from an existing feature attribute (select the attribute name from the pull-down list).
Usage Notes
This transformer has no effect on features that have a geometry other than a face, area or line. Faces, areas, or lines contained within aggregates are not extruded.
Example
Editing Transformer Parameters
Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace. More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers. To access a menu of these options, click 
beside the applicable parameter. For more information, see Transformer Parameter Menu Options.
Transformer Categories
Search FME Knowledge Center
Search for samples and information about this transformer on the FME Knowledge Center.