fmeobjects.FMEPath.snip

FMEPath.snip(measureType, measure3D, startLocation, endLocation)

Take a description of start and end positions (either as a measured 2D/3D distance, percentage, or normalized distance from the beginning, or a vertex index), and chop off only the portion between these positions. If the start and end positions are the same, keep two same points.

Parameters:

• measureType (int) – The measure type to use. Must be on of: SNIP_DISTANCE, SNIP_PERCENTAGE, SNIP_VERTEX or SNIP_POINT.

• measure3D (bool) – Whether to measure the 2D or 3D distance.

• startLocation (float) – The start location.

• endLocation (float) – The end location.

Return type:

None

Raises:

FMEException – An exception is raised if an error occurred.