Adds or removes point orientation.
Features with added or removed orientation.
Features that were not modified by the transformer.
Specifies the representation to use when setting point orientation. The following representations are supported:
Degrees CCW from the X-axis, rotated around the Z-axis.
X component of the normal.
Y component of the normal.
Z component of the normal.
Degrees of rotation around the orientation normal (right hand rule)
X component of the axis.
Y component of the axis.
Z component of the axis.
Degrees of rotation around the axis (right hand rule).
Degrees CW from the positive Y-axis.
Degrees from the XY plane.
The coefficients of the transformation matrix:
x' = Ax + By + Cz
y' = Dx + Ey + Fz
z' = Gx + Hy + Iz
Coefficients A, E and I must be non-zero.
The x coefficient.
The y coefficient.
The z coefficient.
The w coefficient.
The first rotation, around the Z-axis.
The second rotation, around the X’-axis.
The third rotation, around the Z’’-axis.
The first rotation, around the Z-axis.
The second rotation, around the Y’-axis.
The third rotation, around the X’’-axis.
Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace. More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers. To access a menu of these options, click beside the applicable parameter. For more information, see Transformer Parameter Menu Options.
Search for samples and information about this transformer on the FME Knowledge Center.