Rotator

Rotates features in a counterclockwise direction about the specified point by the Rotation Angle parameter (measured in degrees).

The rotation is around the Z axis, and does not impact any elevations that may be present on the feature.

Parameters

Each of the parameters may either be entered as a number, or can be taken from the value of a feature attribute by selecting the attribute name from the pull-down list.

Rotation Angle

Specifies the angle that the feature will be rotated, measured in degrees counterclockwise.

X Origin, Y Origin

The x- and y-coordinates about which features are rotated. The specified coordinates are global and are not relative to individual features. These parameters do not apply when rotating raster geometries.

Note: Raster geometries do not use the supplied origin for rotation. Rasters always rotate around the upper left corner, which is the implied origin.

Editing Transformer Parameters

Using a set of menu options, transformer parameters can be assigned by referencing other elements in the workspace. More advanced functions, such as an advanced editor and an arithmetic editor, are also available in some transformers. To access a menu of these options, click beside the applicable parameter. For more information, see Transformer Parameter Menu Options.

Transformer Categories

Geometries

Technical History

FME Factory Used: @Rotate2D

Search FME Community

Search for samples and information about this transformer on the FME Community.

Keywords: pointcloud