spatialware_type: spatialware_arc
Features with this value are point features with the point specifying the centre of the elliptical arc. This is used by both the reader and the writer.
Note: Currently, only circular arcs are supported by SpatialWare. FME will assign the same value to both the primary and secondary radii when reading, and will use the average of these when writing arcs to SpatialWare.
Arc features have the following special attributes associated with them:
|
Attribute Name |
Contents |
|
spatialware_primary_radius |
The primary radius of the arc. |
|
spatialware_secondary_radius |
The secondary radius of the arc. |
|
spatialware_start_angle |
The start angle of the arc measured in degrees counterclockwise up from the horizontal. |
|
spatialware_sweep_angle |
The sweep angle of the arc measured in degrees counterclockwise. |
|
spatialware_rotation |
The rotation of the primary axis of the arc. The rotation is measured in degrees counterclockwise up from the horizontal. |
|
spatialware_centroid_x |
The feature’s centroid X location. |
|
spatialware_centroid_y |
The feature’s centroid Y location. |
|
spatialware_centroid_z |
The feature’s centroid Z location. |
|
spatialware_is_closed |
YES if the feature is closed. NO if otherwise. |