Output Units
Specifies how FME feature coordinates are interpreted and converted into Units of Resolution (UORs).
Two Point Line Output
Specifies how you want to store the two-point line features.
Controls whether or not fill linkages will be written out for ellipses, shapes, and solids.
Seed File
Set the location of the seed file, which controls whether or not the output design file is two-dimensional or three-dimensional, and sets the models, the global origin, and the unit information of the destination Design file.
Cell Library File
Optional: You can select a design file cell library, which contains definitions of symbols that can be placed in the output design file.
Note: If a translation to design file fails because of insufficient ground range, FME detects this and will automatically supply these settings for the next translation.
Compute Seed File Parameters
Select this option to scan the input data and automatically compute and use optimal parameters for the input data. You may want to use this setting if the seed file you selected does not provide a large enough real-world area for the output data.
This option is supported for v7 only; the values are ignored for v8.
Override Global Origin
You can override the global origin, which is by default at the center of the design plane/cube, by setting the values of X and Y. Setting these values overwrites the global origin as read from the .dgn file.
X: The global origin of X measured in UORs, from the lower left corner of the design plane/cube.
Y: The global origin of Y measured in UORs, from the lower left corner of the design plane/cube.
Override Units: You can overwrite the unit values by checking this box and entering values for sub units, master units, UOR per master unit, and sub units per master unit.